Raven 9MM Side Cover

3D Printed side cover and brass deflector for the 9MM Raven and the Raven 556.  

•  Raven 9MM Side Cover
   Covers the left/right side charging handle slot
  
  

(You need two side covers to cover both charging handle slots)

- Installation Guide

Apply a small amount of thread locker to the screws, IE. Loctite, Permatex, or Vibratite.

Insert the screws into the brass deflector/side cover and start the threads onto the nuts with the tapered side facing inward.

Make sure the nuts are not tightened, only have them barely on so they don't fall off when being inserted into the receiver.

Insert the side cover into the receiver.

Evenly Tighten each screw until they are snug.

Continue to tighten the screws until they are flush and or good enough for your liking.